Products
0102030405
LX-Brand single-component polyurethane waterproof coating
description2
Characteristics
This coating is classified to Type I and Type II on base of tensile strength and viscosity,and applies to different parts of the substrates.
Type lis applied to horizontal surfaces and Type li is applied to vertical surfaces.
The main color of the coating is black;white color can be also provided for your special purpose.
This coating possesses the property of fine tensile strength,elasticity,suitable to cold or hot conditions. Once coated,high density,no cracks,no blisters,strong bondage,resistance to the erosion of water, contamination and moldy.
It is environmentally-friendly coating,no benzene and oil tar,no need to dilute it by solvent.
The elongation at break for Type l is much higher than Type ll,but with lower viscosity,mainly applies to horizontal surfaces;the tensile strength for Type II is much higher than Type I,with high viscosity,non- sagging,mainly applies to vertical surface and closing up the edges.
description2
Application
Widely apply to underground non-exposed building surfaces.
description2
Precaution
Please use up the coating within 4 hours whenever the coating-pail opened,never keep the opened pail for a prolonged time;keep away from children and avoid touch of your eyes;no smoking,no fire at the coating spot;in case splashed into your eyes,flush your eyes with water generously and then see doctors.
description2
Package /Storage /Transportation
Different coatings should be placed and stacked separately,keep away from rain,sunshine,fire,impact, squeezing,upside down;storage temperature should be 5-35 degree Celsius,but in no case more than 40 degree Celsius and with well ventilation;shelf life is one year from the production date.
description2
Working key points
The entire substrate must be clean,smooth,rigid,dry,no sharp debris,no hole,no hollow,no peeling,no oil,no cracks,no deformation joints;if the surface of the substrate is smooth and rigid,no need to coat primer;stir /blend at least 5 minutes evenly.
Coating methods:To coat by roller,brush,scraper or spray;it is better to coat twice or thrice,the time interval should be around 24 hours,the second coating direction should be perpendicular to the former coating,in case one interlayer is required,non-woven fabric should be installed and then coating being done at the same time.
Make sure that there is no ponding /water on the surface of the substrate;if there is ponding /water,you should clean up the water and in 24 hours,you can proceed with your work.
Coating work should be done at the temperature above +5 degree Celsius,and make sure good ventilation,fire extinguisher is required at the working site.
After the A and B component being mixed thoroughly and evenly,it is better to use up within 20 minutes; longer time opened in the air is forbidden to prevent solidification;in case some remaining in the opened pails,re-tight the pail covers is necessary right away.
After finishing the coating works,and if the coating quality is ok after careful examination,the following up protective waterproofing layer can be done.